Click on “check button” or “read button” till its done then click on “initialization button” then click “finish”.Select waste ink pad counter in the maintenance section then click ok or double click the menu.Model 2 of Epson adjustment program (menu section) switch off printer for 5secs then switch on again.Click protection counter to reset counter to zero.Set printer model then click ok (if exist, usually there are adjustment program can be used at more than one printer).Set computer date setting (if the adjustment programs require date setting).

Model 1 of Epson adjustment program(tab version) Some adjustment program requires date setting to run the software without error and other not require. In fact there are two models/versions software resetters or adjustment program for Epson printer (see the picture). Thus you don't need to refill each time a single cart becomes empty as when auto-reset chip carts require.This procedure is applicable for all Epson printers. All will indicate 100% on the ink monitor. What is great about these is that when the first cartridge in the printer runs empty you pull all cartridges out, refill them all, reset the chips by shorting two contacts with tweezers. The first refillable cartridges for the Epson R3000 had the battery powered chips. It does state here that not all printers will have the ink charge function. With my R3000 I'm still using battery powered chips which let me reset them at will.ĭid you download and install the program?

I'm not sure if the EAP also requires 100% ink level before using the recharge function.

You would need to have another set of recently purchased chips that register 100% full to preform the ink charge. There is no way to manually auto-reset the chips. The downside of using this app is that you need all your cartridges to be reset to 100% full or the app won't run. The WICRESET is what you need and will do the Ink Charge for FREE, you need to purchase a Key for waste ink counter reset which you don't need to do. Now you have an alternative app for what you are wanting to to - Initial Ink Charge. Also many sellers on sell the EAP for one printer model only. It's very hard to find the EAP app, look at Ebay, and look where the sellers are from so caution there. That site may still be legit, keep trying to contact them. 'battery powered chips'? That sounds interesting. Alas, the WIC program doesn't do initial ink charging for the p600 - as far as I can see. Thanks again for another helpful reply - it is appreciated.

Epson adjustment program for mac